Emtech-electronics BLU-CIF2 Uživatelský manuál Strana 1

BLU- CIF2 Interface Board BLU-CIF2 Cat5e Wiring Instructions IMPORTANT: IF you are using CAT5e wiring termination

10Old BLU-CC with new BLU-CIF2 using old template

2 BLU-CIF RJ-45 CONNECTIONS TOP ROW BLU-CP1 BLU-CC1A BLU-SV2 BLU-IR2 BTTM ROW BLU-CS/SV1 BLU-CC1B

38-pins, and are located behind the RJ-45 blocks on the top half of the board for DSP1, and on the bottom half of the board for DSP2 . BLU-CP1

4BLU-CC1A & CC2A/SV5 BLU-CC1B & CC2B/SV6 1. Power Button (IN5) 1. Volume (IN6) 2. Volume (IN7) 2. Volume (IN8) 3. Ref

5 There are no switches associated with the C switch connectors on the new version of CIF2 board. IN11 and IN12 are bit encoded with 4 bits

6BLU-CIF2 PWR RELAY & OF RELAY Wiring Instructions The voltage from the +24 pin is typically connected to an external power relay coil, which

7 The 3.5mm connectors on the opposite end of each cable are orange. They match the color of the mating connector on the back of the DSP and are

8wiring that must be done on the new BLU-CIF2 board for these to work properly with the old template. No additional wiring needs to be done when usin

9MSC-C Switches with new BLU-CIF2 using old template: