Emtech-electronics BLU-CIF Uživatelský manuál stáhnout pdf (Strana 4)

A remote control can be used for controlling the volume of the various

microphone inputs in the cultural hall. When wiring for a remote application

wire to IN5 thru IN9, Ref and GND on CC1A, CC1B and SV2.

BLU-CIF / MSC-C Wiring Instructions

There are no switches associated with the C switch connectors on the new

version of CIF board. IN11 and IN 12 are bit encoded with 4 bits each. C-

SW1 and C-SW2 map to IN11, and C-SW3 maps to IN12. When either a C

switch or IR get wired to the CIF board, the device will be automatically

detected. The pin-outs on the C switch connectors are:

Some existing buildings already use Emtech

MSC-C modules to provide chapel audio for the

cultural hall and overflow areas. The BLU-CIF is

designed to allow these existing modules to

interface with the BSS Audio DSP. Located

through the middle section of the CIF Board are

three 4-pin euro-style connectors. Each

connector has identification and wiring

designations silkscreened below it.

1 2 3 4 5 6 7 8 9 10

Žádné komentáře

Emtech-electronics BLU-CIF Uživatelský manuál Strana 4