Emtech-electronics BLU-CC Uživatelský manuál Strana 1

Procházejte online nebo si stáhněte Uživatelský manuál pro Audio Emtech-electronics BLU-CC. Emtech Electronics BLU-CC User Manual Uživatelská příručka

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 3
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 0
BLU-CC2 Remote Control
BLU-CC Wiring Instructions
IMPORTANT: CAT5e wiring for the RJ-45 connector needs to be
crimped to TIA/EIA 568B Standards (see below) on both ends of the cable.
You must crimp and test the wiring with an approved CAT5 568A/B
tester before connecting any cable between the BLU-CC and either a
BLU-CIF or BLU-IF Interface unit. Failure to crimp wiring to the correct
standard could possibly lead to component damage.
EIA/TIA568B
1. White-Orange
2. Orange
3. White-Green
4. Blue
5. White-Blue
6. Green
7. White-Brown
8. Brown
The BLU-CC2 is a 3-input (3-mic or
2-mic & 1-transformer balanced stereo
to mono line input) remote control for
BSS Audio London Series Digital
Signal Processors. It is housed in a 3-
gang wall mountable box with a
latching door. On the backside of the
control, there is a pair of RJ-45 Cat5e
connectors for connecting the BLU-
CC2 to the DSP, and a 3-pin Euro-
block for the audio signal from either
Mic 3 or the Aux Inputs (RCA or
3.5mm) to the DSP.
Zobrazit stránku 0
1 2 3

Shrnutí obsahu

Strany 1 - BLU-CC2 Remote Control

BLU-CC2 Remote Control BLU-CC Wiring Instructions IMPORTANT: CAT5e wiring for the RJ-45 connector needs to be crimped

Strany 2

In addition to adding a 3.5mm stereo jack to the AUX Inputs section of the BLU-CC2, there is a switch on the upper back of the board for setting up t

Strany 3 - Top Mid Bttm

There is a green LED located on the backside of the BLU-CC.

Komentáře k této Příručce

Žádné komentáře